15
19. Reattach the Motor Hood (75) with the four 3/8" x 1 1/4"
Screws (37) that you removed in step 1.
18. Use the included wire ties to secure the wires to the
Power Board (100) and to each other. Make sure that
all wires are properly secured.
Cut off the extra ground wire (H).
Remove the old tech sheet from the pouch (I) and insert
the included new one.
Test the incline trainer to make sure the speed and in-
cline are working properly.
37
100
H
I
75
Tie
Tie
37
19
18
21. Make sure that all parts are properly tightened before you use the incline trainer. To protect the floor or
carpet, place a mat beneath the incline trainer.
20. After the incline trainer is placed in the location where
it will be used (see HOW TO MOVE THE INCLINE
TRAINER on page 33), make sure that both Rear
Leveling Feet (38) and the Base Pads (not shown)
rest firmly on the floor. If the incline trainer rocks even
slightly, turn one of the Rear Leveling Feet clockwise or
counterclockwise until the rocking motion is eliminated.
Wipe clean the surface of the existing serial number
decal.
Remove the backing from the included serial number
decal (J) and place the decal over the top of the existing
serial number decal on the Base Frame (56).
20
38
56
J
