12
10
10. Remove all parts (23, 29, 31, and 32) from the
pulley bracket on the Tower Frame (1).
Route the Weight Cable (40) through the pulley
bracket and downward through the hole in the
center of the Tower Frame (1).
Attach the Small Pulley (23) inside the pulley
bracket with the M10 x 50mm Socket Bolt (29),
the two M10 Washers (31), and the M10
Locknut (32) that you just removed.
Make sure
that the Weight Cable (40) is between the
Small Pulley and the rod on the pulley
bracket.
32
1
31
23
Rod
31
29
40
11
11. Tighten the end of the Weight Cable (40) into
the Large Pulley Bracket (60).
Then, tighten the jam nut on the end of the
Weight Cable (40) against the Large Pulley
Bracket (60).
40
60
Jam Nut
Summary of Contents for FLY/REAR DELT F806.0
Page 24: ...24 NOTES...
