MODEL: PE20V31618G / PE20VT31618
MODEL: PE20V31618G / PE20VT31618
WWW.FREEMANTOOLS.COM
1-888-669-5672
08
WWW.FREEMANTOOLS.COM
1-888-669-5672
09
1.
2.
3.
4.
Remove battery pack from the tool, if
installed.
Turn the Depth Adjustment Wheel (E) left or
right to change the driving depth.
Reinstall battery and reactivate the tool by
pressing the Power Button (F).
Drive a test nail after each adjustment until
the desired depth is set.
NOTE: Set depth of drive at the shallowest
depth that will meet your needs.
LED WORK-LIGHT
The LED Work-light provides feedback to
indicate whether the battery pack is charged
sufficiently and/or if the tool is functioning
properly.
WARNING
:
Keep the tool pointed away from
yourself and others when loading nails.
Failure to do so could result in possible
serious personal injury.
WARNING
:
Use only the nails recommended for use
with this tool. The use of any other nails
can result in tool malfunction, leading to
serious injuries.
WARNING
:
Never load nails with the work contact
element or trigger activated. Doing so
could result in possible serious injury.
If work-light is flashing, install fully charged
battery. If light continues to flash, please call
1-888-669-5672 for assistance.
If the LED light goes out on your nailer, the
unit has timed out for your protection. Press
the Power Button (F) to reactivate the nailer.
•
•
Loading Finish Nails: Insert a stick of
fasteners on the right side of the magazine
rail (D). Make sure the pointed ends of the
fasteners are resting on the bottom ledge of
the magazine.
Push the magazine cover (B) forward until
the latch button (A) pops up.
4.
5.
(A)
(B)
(D)
(D)
DEPTH ADJUSTMENT
The driving depth may be adjusted. It is
advisable to test the depth on a scrap
workpiece to determine the required depth for
the application. To achieve the desired depth,
use the depth of drive adjustment on the tool.
Depth
Adjustment
Wheel (E)
Power Button (F)
WARNING
:
Only load one type of fastener in the
magazine at a time. DO NOT mix fasteners
in the magazine.
ATTACH BELT CLIP
LOADING FASTENERS
The belt clip can be installed on the nailer,
depending on operator preference.
Remove the battery pack or press the Power
Button (F) to turn off the tool before installing
belt clip or hanging the tool on your belt.
Align belt clip and screw tightly with side
screw hole.
Tighten securely using a M4 Hex Wrench
(Included)
1.
2.
3.
Push down on the latch button (A). Pull
back on the magazine cover (B).
Loading Brad Nails: Insert a stick of
fasteners on the left side of the magazine
rail (C). Make sure the pointed end of the
fasteners are resting on the bottom ledge of
the magazine.
Loading Staples: Insert a stick of fasteners
so the crown of the staples straddles the
top of the magazine rail.
1.
2.
3.
REMOVING BATTERY PACK
1.
2.
Press battery release button.
Pull battery free of the tool body.
(A)
(B)
(C)
WARNING
:
Always wear eye protection with side
shields marked to comply with ANSI
Z87.1. Failure to do so could result in
objects being thrown into your eyes,
resulting in possible serious injury.
WARNING
:
Do not hang tool from your belt while
the tool is on. Bumping the tool against
work surfaces or dropping the nailer
while the tool is on may cause misfiring
and personal injuries.
Power Button (F)
(C)
(A)
(B)
(C)
(C/D)