P25
HARDWARE
MOUNTING PLATES
There are a series of mounting plates along the front of the controller with 1/4-20 threaded holes. To mount the MōVI Controller to a
tripod using these plates, attach the tripod plate to any of the 1/4-20 threaded holes and rotate the tripod head to the desired angle.
HEAT SINK
The heat sink located on the back of the controller has a 1/4-20 thread that can be used to mount the MōVI Controller to a tripod when
an IDX plate is not attached.
TRIPOD ADAPTER
PLATE
The MōVI Controller comes with a tripod mounting plate installed. The tripod mounting plate is attached to the rear mounting plate and
has both 1/4-20 and 3/8-16 tapped holes for mounting to a tripod.
+ Insert the 1/4-20 x 1.25” set screw through the top, center hole of the tripod adapter plate into the mounting plate located on the back of the controller.
+
Tighten the set screw using a 1/8” or 3mm hex driver.
+
Make sure the knurled set screw on the Giottos mini ballhead mount is tight, and thread the monitor onto the 1/4-20 thread on the mini ballhead mount.
+ With the screen attached and the knurled set screw on the Giottos mini ballhead still tight, thread the mini ballhead mount onto the 1/4-20 set screw.
+ To adjust the screen position, loosen the knurled set screw and rotate the mini ballhead housing and adjust the monitor angleuntil the monitor is in the
correct orientation.
+ Tighten knurled set screw to lock monitor in place.
MOUNTING TO TRIPOD
There are several options for mounting a tripod on the MoVI Controller.
ATTACHING MONITOR
The MōVI Controller comes with a Giottos mini ballhead mount and set screw for mounting a monitor. To install a monitor:
