TCA200 Rev171031
11
Install Pressure Sensors
The two pressure sensors are mounted on the discharge and intake manifolds of the
pump. If there is a check valve in the discharge side of the pump, mount the discharge
sensor before the check valve. T-fittings can be used to mount the pressure sensors.
Note:
Install the pressure sensor upright so that the water in the end of the
pressure sensor is able to drain back into the pipe.
1. Screw the sensor into a 1/4-18 NPT hole.
Caution:
Do not use the main body that houses the electronics to tighten the
pressure sensor. Damage to the sensor may occur.
2. Tighten the sensor with a 7/8 inch wrench on the lower hex fitting.
3. Connect the pressure sensor cable from the control module to the pressure
sensor. (Refer to Wiring Section.)
Figure 3. Pressure Sensor Dimensions
Caution:
Do not use the main
body that houses the electronics
to tighten the sensor. Damage to
the sensor may occur.
Caution:
The discharge and intake
pressure sensors are the same size.
Ensure the correct sensor is installed on
the correct manifold. Refer to Table 1.
1/4-18 NPT
7/8" Hex
0.75 [18.95]
2.37 [60.30]
Inch [mm]
Packard
Metri Pack
Connector
0.87 [22.05]
Across Flats
Summary of Contents for TCA200
Page 32: ...TCA200 Rev171031 32 ...
