9
Commissioning the system
1. Install the filter cartridge into the filter housing. (Refer to
the separate Cartridge Change Instructions in the filter
system box).
2. Turn on the water supply.
Operate the boiling water function for 3 minutes to
flush the system. (Please see the OPERATING THE
OMNI TAP overleaf.)
3. Turn the tap off and check the connections for leaks.
4. Plug the boiler into the mains electricity supply socket.
5. Remove the warning strip covering the “ON-OFF” switch
on the front of the boiler and turn the switch to the “ON”
position. Check the top LED (Plug logo) on the boiler
turns green to indicate power is on. The lower LED (Mug
logo) will turn red to indicate the boiler is heating up.
6. Wait for 10 minutes and then check that water is
discharging from the vent pipe.
Important note:
If water
does not start to discharge from the vent pipe into the
cup after 10 minutes, switch off the power, operate the
boiling water function on the tap to release the pressure,
and refer to the Troubleshooting Guide overleaf.
7. Allow approximately 20 minutes for the boiler to reach full
operating temperature, indicated by the lower LED
turning green.
8. Operate the tap boiling water function for a minute to
exhaust trapped air from the system.
9. The system is now ready for use. Please demonstrate to
the homeowner the procedure for replacing the water
filter cartridge and explain the importance of scheduled
cartridge changes to maintain the quality of the filtered
drinking water and the boiler warranty.
Top LED indicates
power on/off
Bottom LED
Red=tank is heating
Green=ready
Warning strip
Top LED indicates
power on/off
Bottom LED
Red = tank is heating
Green = ready
Warning strip
