– 6 –
FMY 839 HI
EN
Cabinet requirements
X
Z
The cooking hob is intended to be built
into the worktop above a kitchen cabinet
of 600 mm width or more.
X
Z
If fitting in flammable material, the
guidelines and standards for low voltage
installations and for the fire protection
must be strictly observed.
X
Z
For fitted units, the components (plastic
materials and veneered wood) must be
assembled with heat-resistant adhesives
(min. 100 °C): Unsuitable materials and
adhesives can result in warping and
detachment.
X
Z
The kitchen cabinet must allow sufficient
room for the electrical connections of the
appliance. Suspended kitchen cabinets
above the appliance must be installed at
a distance that provides enough room for
comfortable working process.
X
Z
The use of hard wood decorative borders
around the worktop behind the appliance
is allowed, in this case the minimum
distance remains as indicated on the
installation illustrations.
X
Z
The minimum distance between the built-in
appliance and rear wall is indicated at the
illustration for the installation of the built-in
appliance (150 mm for the side wall,
40 mm for the rear and 500 mm minimum
for any cabinets above it).
X
Z
To prevent leakage of liquid between the
edge of the hob and the countertop, place
the adhesive seal provided along the entire
outer edge of the hob before assembly.
Proper use
X
Z
The extractor appliance has been designed
exclusively for domestic use to eliminate
kitchen smells.
X
Z
Never use the appliance for purposes
other than for which it has been designed.
X
Z
Deep fat fryers must be continuously
monitored during use: overheated oil can
burst.
X
Z
Do not operate the appliance with an
external time switch or a separate remote
control system.
X
Z
The appliance shall not be installed
behind a decorative door in order to avoid
overheating.
X
Z
To avoid damaging the appliance do not
climb onto the appliance.
X
Z
To avoid damaging the silicon grouting, do
not put hot cookware on the frame.
X
Z
Do not cut or prepare food on the surface
or drop hard objects onto it. Do not drag
cookware across the surface.
ELECTRICAL CONNECTION
X
Z
The wire connection has to be done by specialized
technician.
X
Z
This appliance has a Type “Y” attachment and requires
at least a power supply cord Type H05VV-F. MONO-
PHASE, BI-PHASE and THREE-PHASE connection: min.
section of the conductors: 2,5 mm². External diameter
of the supply cord: min. 7 mm - max. 15 mm
X
Z
Connection terminals are revealed when the
connection box cover is removed.
X
Z
Make sure the characteristics of the household electrical
system (voltage, maximum power and current) are
compatible with those of the appliance.
X
Z
Connect the appliance like shown in the diagram
(in accordance with the mains voltage and country
standard reference).
X
Z
We suggest to use power supply cord 5 x 2.5 mm²
H05V2V2-F. In case of use of power supply cord
5 x 2,5 mm² H05V2V2-F, below instructions have to
be followed: for three-phase connection separate the
2 wires and remove the blue sheaths on grey wires.
