F3D Operating Manual
Page 7
3
Start-Up Procedure
1 Dry All Parts
Using a clean, sanitized towel, wipe down the freezer
s interior, chute
doors, and the dispense area to remove any remaining moisture.
Make sure all that all components that were removed for cleaning are
completely dry before installing them.
2 Assemble Unit
Install all removable components as follows:
§
Place the main drip tray and wire basket
guides into the dispense area.
§
Hang the side basket rack storage rack onto
supports on the cabinet
s left side.
§
Place the side drip tray at the bottom of
basket storage rack.
§
Position and press the freezer bottom into
the cabinet, over chute door frames. Make
sure the corner slots are facing you.
§
Place the product chutes into the freezer
bottom, onto the chute door frames. Make
sure chutes seat properly into their frames.)
§
Push the rubber deflectors, small edge first,
into the slots cut in the side of the hopper.
§
Place the fry hoppers in the freezer, making
sure drive hub fully engages the drum.
(Tip: You may need to turn the drum slightly,
using the front turn handle, while pushing the
hopper in place to engage the hub.)
