F3D Operating Manual
Page 12
§
Remove rubber deflectors from hoppers.
§
Remove product chutes from chute door frames.
§
Remove freezer bottom from cabinet.
§
Remove side basket drip tray.
§
Remove wire basket racks from main drip tray.
§
Leave main drip tray in place for now, to collect dripping water
while the freezer defrosts.
§
Leave freezer door ajar to allow frost to melt.
Note! Never defrost the freezer by scraping the inside walls,
regardless of how much ice is present. The only proper method
of defrosting is to turn the freezer off and allow frost to melt.
4 Wash and Sanitize Removable Components
Place all removed components in the sink; wash and sanitize.
Note! Use only warm water, not hot water, when cleaning the
hoppers. Excessively hot water can cause the hopper to warp.
5 Drip-Dry Components
Place components so that they will drip-dry overnight.
Leave the hoppers on a flat, clean surface to drip-dry
NOT the top of
the sharp wall between sink bowls.
Note! Do not put any WET parts back in the cold freezer.
The parts could freeze together and damage the machine.
6 Clean Non-Removable Components
Wait for frost to melt from the walls of the freezer. Then:
