F3D Operating Manual
Page 6
Note! Use only warm water, not hot water, when cleaning the
hoppers. Excessively hot water can cause the hoppers to warp.
7 Drip-Dry Components
Place components so that they may drip-dry.
Leave the hoppers on a flat, clean surface to drip-dry
NOT the top of
the sharp wall between sink bowls.
Note! Do not replace WET parts in the freezer. The parts could
freeze together and cause damage to the machine.
8 Clean Non-Removable Components
§
Wipe down, sanitize and dry the freezer interior and the chute
doors. Tip: The chute door frames are hinged. You can gently
push them open to fully clean the chute doors and door frames.
§
Wipe down and sanitize the side basket hanger rack.
§
Wipe down and sanitize the surface beneath the drip tray.
§
Close the freezer door.
2
Temperature Setting
The F3D
s internal, adjustable thermostat maintains the correct MacFries
storage temperature range (0° to
10° F.). This thermostat is properly
calibrated and tested at the factory prior to shipment from Franke.
A digital thermometer on the control panel displays the actual operating
temperature. If adjustment becomes necessary, you can access the
thermostat by removing the bottom front louvered panel.
