- 11 -
ZMI
_001_
2030
0185
75-A
Q
LT
0098
_#SE
N
_#AQ
U
_#V3
.f
m
19. Replacing the filters
Water volume regulator filters
19.1
Remove the shower panel(see
19.2
Unscrew the locking screws (a) on the water volume regulators.
19.3
Replace the filters (b).
☞
Important!
Note the installation position of the filters.
19.4
Reassemble in reverse order.
20. Replace the thermal element
Warning!
Set the scald protection after installing the fitting or removing the thermal element.
Failure to observe this instruction can result in injuries due to scalding.
20.1
Close the water volume regulators (see
).
20.2
Trigger the fitting.
20.3
Remove the temperature selector (see
20.4
Remove the screw (b)
Caution!
Apply the pliers to the area with the largest diameter (a) behind the small sprocket
wheel.
If the sprocket wheel is damaged, the temperature selector cannot be installed.
20.5
Use pliers to remove the thermal element (c).
☞
Important!
Note the installation position of the thermal element.
20.6
Reassemble in reverse order.
20.7
21. Replacing the flow rate regulator
21.1
Release the grub screw with an Allen key.
21.2
Pull the shower head out of the connection pipe.
21.3
Remove the locking ring on the inside using appropriate pliers for locking rings.
21.4
Pull out the flow rate regulator using flat-nosed pliers.
21.5
Replace the flow rate regulator. Observe the table.
Flow rate
Flow rate regulator
0.15 l/s (orange)
FAR-Best.-Nr. 2000104782
0.20 l/s (red)
FAR-Best.-Nr. 2000104783