FRANCO srl Manual of use and maintenance UCP-fly
18
D.
Using a screwdriver (pic no.10) tighten the
screw. By tightening the screw into the hole the
disk will be pulled out effortlessly.
E.
Once the disk is out, unscrew the M6x40 screw
and take it off the hole.
F.
Grease the motor shaft and insert the new disk. Check that the keys are well aligned, then press on
the centre. Do not beat on it and do not press excessively hard. Place the washer in its place, as well
as the screw M4 and the cap.
The distance between the spinning disk and the fixed disk must be about 4mm. If it is not, adjust it by
adding a spacer or taking a spacer off the motor shaft (item 5 and 6 on the spare parts list
– see
paragraph 5.3).
4.7 Replacing the fan
Use a no.7 wrench to remove the 4 screws holding the safety grill. With a no.7 screwdriver unscrew the screw on
the fan impeller. Remove the fan.
Before positioning the new fan, grease the driveshaft, being careful not to misplace the key. Make sure that the
screws are replaced properly, fixing the fan and the safety grill.
4.8 Accessories
A full range of accessories matching your UCP is available, including electronic humidity controls, thermostats,
timing systems for the drainage of the tank (anti-legionella), electric wiring accessories, hydraulic accessories,
air conveying and inhalation channeling pipes.
Request the accessories catalog from your dealer for further details.
10
