FRAM FHM-400CR, Manual

Page: 11 / 25

10
BEFORE INITIAL USE
Remove any packages, disassemble any detachable parts. Clean the dough hooks and beaters.
Before assembling the mixer, make sure the power cord is unplugged from the power outlet and
the
speed selector is at the “ 0 ” position .
USING YOUR MIXER
1. Assemble proper beaters or dough hooks into mixer.
NOTE : Beaters can be inserted in either socket, as the beaters are identical. For dough hooks, the
one with washer can only be inserted into the bigger socket and the other one can only be inserted
into smaller one. The two dough hooks can not be inserted in reverse.
2. Ensure that the unit is at the
“ 0 ” setting, then plug in the power source.
3. Set the speed selector to your desired speed. There are 6 speed settings to be selected. When
kneading yeast dough, suggesting to select the speed selector by lower speed and then by higher
speed to achieve the best results. The mixer will run at the highest speed when pressing turbo
button.
WARNING: Do not stick knife, metal spoons, fork and so on into bowl while operating.
4. The max operation time per time shall be less than 5 minutes. Minimum 20 minutes rest time
must be maintained between continuous two cycles.
NOTE: During operation you may rotate the bowl with hand to achieve the best results.
5. When mixing is complete, turn the speed selector to “ 0 ” setting, and unplug the cord from power
outlet.
6. If necessary, scraping the excess food particles from the beaters or dough hooks by rubber or
wooden spatula.
7. Hold the beaters or dough hooks with one hand and press the
Ejector button firmly down with
the other hand to remove the beater or dough hooks.
NOTE:
1). Remove the beaters or dough hooks only the speed selector at the “ 0 ” setting.
2). During operation, you can put the mixer vertically, but make sure the speed selector is at the “ 0 ”
setting.
INSTRUCTION OF THE FIXING BRACKET
There is a fixing bracket for storing beaters and dough hooks. After using, you can fix the beaters
and dough hooks into bracket, then insert the bracket into the main unit.
5. USING THE APPLIANCE