4
Technical specifications
Capacity
12 place settings
Dimensions (mm)
Height
850 (mm)
Width
598 (mm)
Depth
598 (mm)
Net weight
45.8 kg
Operating voltage / frequency
220-240V
50Hz
Total current (A)
10(A)
Total power (W)
1900(W)
Water supply pressure
Maximum: 1 (Mpa)
Minimum: 0.03 (Mpa)
Machine positioning
•
When positioning the machine, place it in an area where dishes can be easily loaded and unloaded.
Do not put the machine in an area where the ambient temperature falls below 0°C.
•
Read all warnings located on the packaging before removing the packaging and positioning the
machine.
•
Place the machine close to a water tap and drain. Take into consideration that the connections will
not be altered once the machine is in position.
•
Do not hold the machine by its door or panel.
•
Leave an adequate distance around the machine to allow ease of movement when cleaning.
•
Ensure the water inlet and outlet hoses are not squeezed or trapped and that the machine does not
stand on the electrical cable while positioning.
•
Adjust the feet so the machine is level and balanced. The machine should be placed on flat ground
otherwise it will be unstable, and the door of the machine will not close properly.
Water connection
•
We recommend fitting a filter to your water inlet supply in order to prevent damage to your machine
due to contamination (sand, rust, etc.) from indoor plumbing. This will also help prevent yellowing
and deposit formation after washing.
•
If models are marked with 25°, the water temperature may be max. 25 °C (cold water).
•
For all other models: Cold water preferred; hot water max. temperature 60 °C.
Water inlet hose
WARNING:
Use the new water inlet hose supplied with your machine, do not use an old machine’s hose.
WARNING:
Run water through the new hose before connecting.
WARNING:
Connect the hose directly to the water inlet tap. The pressure supplied by the tap should be a
minimum of 0.03 MPa and a maximum of 1 MPa. If the pressure exceeds 1 MPa, a pressure relief valve
must be fitted between the connection.
WARNING:
After the connections are made, turn the tap on fully and check for water leaks. Always turn off
the water inlet tap after a wash program has finished.
5.
INSTALLATION