16
Whitish stains remain on dishes.
Not enough detergent used.
Use the correct amount of detergent,
as instructed in the program table.
Rinse aid dosage and/or water softener setting set
too low.
Increase rinse aid and/or water
softener level.
High water hardness level.
Increase water softerner level and add salt.
Salt compartment cap not closed properly.
Check that the salt compartment cap
is closed properly.
Dishes do not dry.
Drying option is not selected.
Select a program with a drying option.
Rinse aid dosage set too low.
Increase rinse aid dosage setting.
Rust stains form on the dishes.
Stainless-steel quality of the dishes is insufficient.
Use only dishwasher-proof sets.
High level of salt in wash water.
Adjust the water hardness level using
water hardness table.
Salt compartment cap not closed properly.
Check that the salt compartment cap
is closed properly.
Too much salt spilled in the Dishwasher while filling
it with salt.
Use funnel while filling salt to
the compartment to avoid
spillage.
A poor mains grounding.
Consult a qualified electrician immediately.
Detergent remains in the detergent
compartment.
Detergent was added when the detergent
compartment was wet.
Make sure detergent compartment is
dry before use.
Water remains inside the machine.
Water drain hose is clogged or twisted.
Check the drain hose, then either clean
or untwist it.
The filters are clogged.
Clean the filters.
The program is not finished yet.
Wait until the program is finished.
Machine stops during washing.
Power failure.
Check mains power.
Water inlet failure.
Check water tap.
Shaking and hitting noises are heard
during a wash operation.
The spray arm is hitting the dishes in the lower basket.
Move or remove items blocking the
spray arm.
Partial food wastes remain on the
dishes.
Dishes placed incorrectly, sprayed water not reaching
affected dishes.
Do not overload baskets.
Dishes leaning each another.
Place dishes as instructed in the section on
loading your dishwasher.
Not enough detergent used.
Use the correct amount of detergent,
as instructed in the program table.
Wrong wash program selected.
Use the information in the program table
to select the most appropriate program.
Spray arms clogged with food waste.
Clean the holes in the spray arms with
thin objects.
Filters or water drain pump clogged or filter misplaced.
Check the drain hose and filters are
correctly fitted.