14
NOTE:
Do not open the door before the program is complete.
NOTE:
If the door of the machine is opened or the power is cut off while a program is in operation, the
program will continue when the door is closed or the power returns.
NOTE:
If the power is cut or the machine door is opened during the drying process, the program will
terminate. Your machine will now be ready for a new program selection.
Buzzer Sound Control
To change the buzzer sound level, follow the below steps:
1.
Open the door and press Program (2) and Delay (4) buttons simultaneously for 3 seconds.
2.
When sound setting is recognized, buzzer gives a long sound and machine will display last set level,
from “S0” to “S3”.
3.
To decrease sound level press Program button (2). To increase sound level, press Delay button (4).
4.
To save the selected sound level, turn off the machine.
’’S0’’ level means all voices are off. Factory setting is “S3”.
Cleaning your dishwasher is important to maintain the
machine’s service life Make sure that the water
softening setting (If available) is done correctly and correct amount of detergent is used to prevent limescale
accumulation. Refill the salt compartment when the salt sensor light comes on.
Oil and lime may build up in your Dishwasher over time. If this occurs:
•
Fill the detergent compartment but do not load any dishes. Select a program which runs at high
temperature and run the Dishwasher empty. If this does not clean your Dishwasher sufficiently, use
a cleaning agent designed for use with dishwashers.
•
To extend the life of your dishwasher, clean the appliance regularly on each month.
•
Wipe the door seals regularly with a damp cloth to remove any accumulated residue.
Cleaning machine and filters
Clean the filters and spray arms at least once a week. If any food waste remains on the coarse and fine
filters, remove them, and clean them thoroughly with water.
a)
Micro Filter
b)
Coarse Filter
c)
Metal Filter
To remove and clean the filter combination, turn it counterclockwise and remove it by lifting it upwards (1).
Pull the coarse filter out of the micro filter (2). Then pull and remove the metal filter (3). Rinse the filter with
lots of water until it is free of residue. Reassemble the filters. Replace the filter insert and rotate it clockwise
(4).
10. CLEANING AND MAINTENANCE