7) TIMER
Timer – turning on the device:
used to automatically turn on the device after a specified time
• Press the timer button to set the desired time
• After the specified time, the device automatically turns on
• If the power button is pressed before the set time, the device will start immediately, the time set on the timer will be cancelled.
• While setting the timer, it is possible to set the functions and speed of the fan.
Timer
– turning off the device: used to automatically turn off the device after a specified time
• Press the timer button to set the desired time
• After the specified time, the device automatically turns off
• If the power button is pressed before the set time, the device will turn off immediately, the time set on the timer will be cancelled.
8) OSCILLATION
Press the oscillation button to turn on the oscillation of the cold air outlet. Press again to stop. The shutters will return to the star-
ting position when the device is turned off.
9)/10) /11)/ FAN SPEED
– press to select low (LOW), medium (MID) or high (HI) speed
10) OPERATION OF THE AIR CONDITIONER OUTSIDE THE ROOM (OPTION)
10. OPERATION OF THE AIR CONDITIONER OUTSIDE THE ROOM (OPTION)
Connect the pipe using the cold air outlet adapter. In this way, the air conditioner can supply cooled air into the room. This results
in an increased efficiency of cooling the room by about 30% and a significantly reduced noise.
Absolute conditions for such use are:
1. In the cooling mode, the outdoor temperature must be lower than 40°C. The set-up location must be shaded and airy.
3. Despite the structure protecting against direct rain, it is recommended to protect the device against water spray, fog and pre-
cipitation (rain, snow).
4. Protect the device against excessive dust.
11. OPERATION OF THE AIR CONDITIONER WITH THE SECOND PIPE (OPTION)
With the application of the inlet air adapter (plenum), it is possible to convert the air conditioner into a two-pipe device. This
results in a greatly improved efficiency of cooling the room.
NOTE:
The plenum limits the amount of air supplied to the condenser of the device.
Do not use the air conditioner with the mounted plenum in a room (surrounding), where the temperature exceeds 32°C and do
not extend the air inlet pipe to the plenum or the hot air exhaust pipe supplied with the air conditioner.
12. WATER DRAINAGE
The device can automatically discharge and evaporate the collected water.
1. If the device works in the cooling mode, there is no need to install the connection discharging the water. Ensure that the rubber
stoppers are in place.
2. If the device operates in the dehumidification mode, remove the rubber stopper (1) and install the hose for a constant water
drainage. For the best results, the dehumidified room should be closed (no flow of moisture from the outside). Both cold and hot
air flowing out of the device should remain in the dehumidified room. The condensed water should be drained through the upper
outlet (No. 1 in the figure below) using the fixed hose for discharging water to the floor drain or out of the room. It is permitted to
collect the water in a sufficiently large vessel.
ATTENTION! This requires constant supervision, so that the accumulated water does not overflow.
When the water tank is full, the display will show the “E4” symbol. Remove the rubber stopper (2) to pour out the excess water.
When the “E4” symbol disappears from the display, restart the device.
FRAL SUPER COOL FSC09C
PORTABLE AIR CONDITIONER
19
INST. _PL_EN_DE_FSC09C_WER.3
