6. PARTS LIST
Note: To remove the adapter with the pipe, repeat all the steps in reverse order.
4. Screw the pipe into the hot air pipe adapter of the air conditioner, turn it at least three times, and then fasten the pipe to the hot
air outlet in the air conditioner. The process is presented below:
1. Control Panel
2. Remote control sensor
3. Cold air outlet
4. Evaporator filter
5. Air inlet to the evaporator
6. Upper water drain
7. Hot air outlet
8. Condenser filter
9. Air inlet to the condenser
10. Lower water drain
If the device will be used mostly as the air conditioner, we recommend to assemble the hot
air pipe in the window, the window set available as an option. Open the window partially,
and insert the adapter horizontally or vertically. Push the pipe to the end of the adapter and
make sure there is no possibility of disconnecting it.
Note:
The window set is designed for leaf or sliding windows and doors. In the case of other
models of windows, the set will not be suitable. Ensure that the air flow from the outside is
minimal.
Important distances:
The pipe extends from 28 cm to 130 cm. If the pipe extends above this length, it may not
be most efficient. The most appropriate length is 40 cm. The hot air exhaust pipe must be
installed correctly, otherwise the device may overheat. Do not bend the pipe more than by
30 degrees
7. INSTALLATION OF THE WINDOW SET
FRAL SUPER COOL FSC09C
PORTABLE AIR CONDITIONER
16
INST. _PL_EN_DE_FSC09C_WER.3
