- Transport speed
20 km/h
- Cut height
3 – 9 cm
- Mower mass
185 kg
Storage of the rear tractor mower
-
Storage preparations -
1. If you do not use the mower for a longer period of time, then all the parts that come in contact with
the soil and the grass must be completely cleaned from the ground and grass.
2. After cleaning, wash the whole tool well.
3. Replace all damaged or broken blades or double fingers.
4. Tighten all nuts and bolts on the mower.
5. Clean rusted surfaces and bare spots and shade with protective paint.
6. Put the mower on a wooden base located under a canopy or in a separate room.
CAUTION:
1. NEVER WEAR CLOTHES THAT CAN BE TRAPPED IN THE CARDAN SHAFT, OR ANY
OTHER WINDING PARTS.
2. DO NOT DRIVE OTHER PERSONS ON THE TRACTOR OR MOWER.
3. AFTER EACH WORKING SEASON, WE RECCOMMEND THAT YOUR SERVICE FPM
AGROMEHANIKA AD BOLJEVAC, CHECKS THE CONDITION OF THE MOWER,
ESPECIALLY THE BLADE AND OTHER PARTS.
4. ALWAYS COMPLY WITH THE INSTRUCTIONS IN THIS MANUAL.
Jointed coupling - cardan shaft
It is very important that the cardan shaft be
properly adjusted when attached to the tractor. In
no way should the cardan joints, when the tool is
raised to the highest or lowest position, shut down
each other.
If you believe that the cardan shaft is longer and
cannot be connected to the tractor, it is necessary to
cut it. The following illustrations show an example
of shortening the cardan shaft.
4.—
5.—
Knock down the sharp edges, figure 14.
Clean and lubricate, figure 15.
Connect one cardan to the other and it’s
done
1.—
Attach one half of the cardan shaft to the
tractor and to the mower, hold the halves next
