21
U35 FPI Direct Vent Gas Insert
Burner/Rear Log Support Assembly: After
removing the screws slide to the left to
remove the assembly from the firebox base.
Left Side Burner
Bracket
Burner Orifice
Lift Burner/Rear Log Support assembly up
and away from the burner orifice.
MAINTENANCE
2) Unplug or disconnect power source to
stove.
3) Remove glass front (see page 10).
4) Remove logs.
5) Remove brick panels, if used.
6) Straighten the adjustment wire under the
firebox base.
FAN MAINTENANCE
If your fan requires maintenance or replace-
ment, access to the fan is through the plate on
the floor of the firebox. NOTE: the unit MUST
NOT be operated without the fan access
panel securely in place.
Caution: Label all wires prior to discon-
necting when servicing controls. Wir-
ing errors can cause improper and dan-
gerous operation. Verify proper opera-
tion after servicing.
To Remove Fan:
1) Turn the unit off and allow it to cool to room
temperature.
Bay Glass Replacement
1) Remove the door from the unit and place on
a soft surface to prevent scratching.
2) Remove the nuts holding the glass clips in
place and remove.
3) Replace the glass. The glass must have
gasketing around it.
5) Reverse the previous steps, replace the
glass clips and fasten with the nuts but do
not over tighten, as this can break the
glass.
6) Replace door on the stove and check the
seal.
Straighten adjustment wire.
7) Remove the Burner/Rear Log Support as-
sembly by removing the 2 screws (1 on
each side) and sliding the assembly to the
left to free the bottom brackets from the
screws on the firebox base.
8) Lift the Burner/Rear Log Support assembly
up and away from the orifice.
9) Remove the 8 screws holding the Access
Panel in place.
DOOR GLASS
Your FPI stove is supplied with high tempera-
ture, 5 mm Neoceram ceramic glass that will
withstand the highest heat that your unit will
produce. Do not abuse the glass by striking the
surface or by slamming the door shut.
If your glass requires cleaning, we recommend
using an approved glass cleaner available at all
authorized dealers. Do not use abrasive
materials. Do not clean the glass when
hot.
In the event that you break your glass by impact,
purchase your replacement from an authorized
FPI dealer only, do not use substitute materials.
Follow our step-by-step instructions for re-
placement. Caution: Wear gloves when
removing damaged or broken glass.
Warning: Do not operate appliance with
glass panels removed, cracked or bro-
ken. Replacement of the glass should be
done by a licensed or qualified service
person.
Flush Glass Replacement
Remove the flush door front. Remove the 4
glass clips from each corner. Slide in the new
replacement glass. Push the 4 glass clips back
onto the frame.
Clean any fingerprints off before turning
the unit on. If the top louvers start to
discolour, check the door gasket seal
and replace if necessary.