12
U35 FPI Direct Vent Gas Insert
INSTALLATION
BAY LOUVERS
1) Install top louver by sliding the two brack-
et clips into the brackets located on top of
the bay door. See below. The fitted louver
leaves a small gap between faceplate
bottom and louver top.
Diagram 4
OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the
flush front. The standard flush door and glass
must remain on the unit. Hook the top of the bay
door over the flush door flange and swing the
bottom against the bottom flange of the flush
door. Press down on the Bay Bottom bracket
and push in until it clips behind the bottom of the
flush front.
Slide the valve extension knobs onto the valve
knobs. Match each extension knob with the
corresponding valve knob. Extension knobs
are for Bay Front installations only.
Diagram 3
Extension knobs
for Bay Front only.
OPTIONAL BAY TRIM
Attach 4 supplied magnets each to the back of
the top and bottom trim pieces, and attach trim
to the top and bottom of Bay door. See diagrams
3 and 4.
Removing Bay Door
To remove only the Bay Door - use a screw-
driver to unclip the Bay Bottom bracket from the
flush door and then swing up and unhook from
the top flush door flange.
To remove the Bay Door & the Flush Front
together, pull the hook from the slot in the
bottom door bracket under the unit (see Stand-
ard Flush Door instructions above). Then pull
the Bay Door and Flush door out and lift off of
the flange at the top of the unit.
Note: If any maintenance etc. must be
done in the firebox, first remove
the Bay louvers and door.
2) Install bottom louver by sliding the two
bracket clips into the brackets located un-
derneath the bay door. Secure with 1 screw
into each Bottom Louver Mounting Bracket
as per diagram below. Use the bottom hole
in the bracket.
DOUBLE SCREEN
DOOR
1) Pull out the top louver.
2) Center the screen door and hook over the
flush door.
Clip locations
Clip installed on right side.
3) Open the screen door(s) and secure the
screen door to the flush door front with 2
clips on the bottom left and right side.
3) Slide the valve extension knobs onto the
valve knobs. Match the correct ext. knob
with the valve knob.
