15
L a
a: 1 – 1440
Loop the following instructions (a) minutes until loop end
parameter “E” is encountered.
E
Designates the end of an instructional loop.
A a
a: 0 – 1
Set the state of the auxiliary signal line. Can be used if the
signal state needs to be held steady for control of the
connected device.
0 = off
1 = on
D a
a: 0 – 1
Set connected decoy(s) on or off.
1 = activate decoy
0 = deactivate decoy
J
n/a
Denotes Jukebox Mode for this FOXCAST File
R
n/a
Denotes Repeat Mode for this FOXCAST File
Q
n/a
Denotes Single Play Mode for this FOXCAST File
;
Any
Represents a comment line.
A typical FOXCAST sequence file may look similar to the following example (note the included comments for
additional clarification):
Example FOXCAST Sequence File Layout
V 20
; Set Volume to 20
S 15 2
; Play sound 15, 2 times
P 90
; Pause for 90 seconds
L 10
; Start of 10 minute loop
V 30
; Set volume to 30
S 80 3
; Play Sound 80, 3 times
D 1
; Turn on decoy
V 25
; Set volume to 25
S 44 6
; Play sound 44 six times
D 0
; Turn off decoy
P 30
; Pause for 30 seconds
E
; End of loop
Q
; Quit the sequence
A FOXCAST sequence must always begin with a volume. Without defining a volume level, the caller will
default to volume level 0. A FOXCAST sequence file must always end with a specific ending statement. “J”
represents jukebox mode. When you end a sequence with “J”, once the sequence has played through a
single time, it will automatically begin playing the next FOXAST sequence. “Q” represents quit. Once the
sequence has played entirely, the HammerJack will go silent. “R” represents repeat. Once the sequence has
played entirely, the HammerJack will play that sequence again until it is interrupted by the operator. The
HammerJack can accept up to 10 FOXCAST sequence files. These files will need to be in a format similar to
the following examples:
Example FOXCAST Sequence File Names
S00 My Coyote Sequence 1.seq
S01 My Bobcat Sequence.seq
S02 Mountain Lion Calls.seq
As you can see above, each file can be broken down into three parts. The first part is the identifier
(prefix/index) for the particular sequence. For example, “S00” indicates that this is the FIRST sequence in
the HammerJack. The second part of the name, “My Coyote Sequence”, describes the title of this sequence.
Summary of Contents for Hammerjack
Page 1: ......