101364
Model
FT2
3.8.
Resetting Total and Elapsed Time
Pressing F3 and F4 at the same time in the normal running mode brings the prompt to reset the
totalizer and elapsed time:
Reset Total ?
NO YES
F1
F2
F3
F4
If the password is active the program will prompt the user to enter the password:
PASWD:
UP DN NXT OK
F1
F2
F3
F4
If the password is correct, the reset will be performed, otherwise a “Wrong Password” message will be
displayed briefly before returning to the normal mode.
Note: To disable the programmable password set it to “0”.
3.9.
Alarm Indications
Alarm indications are provided to indicate any malfunctions, out of range values or saturated analog
outputs.
The following list is a description of alarm codes:
Code Description
12
Power up Initializing
13
Flow rate above high limit
14
Flow below low limit
15
Temperature above high limit
16
Temperature below low limit
22
Sensor out of range
23
Velocity out of calibration table range
24 Check
settings
25 Simulation
mode
26
Frequency output over range
32
4 to 20 mA for flow rate is out of range
33
4 to 20 mA for temperature is out of range
34
ANYBUS communication error
35 RTC
Error
36
EEPROM CRC Error
37 Totalizer
error
detected
Fox Thermal Instruments Inc., 399 Reservation Road, Marina, CA 93933
Page 27
