Fox F36-527, Assembly And Operating Instructions Manual

Page: 13 / 24

ASSEMBLING, ADJUSTING AND USING THE MACHINE
CAUTION
Always remove the plug from the power source before carrying out any maintenance, cleaning or assembly work on
the table saw.
When assembling the stand we advise you only loosely tighten the screws until the stand is fully assembled.
NOTE : the stand legs are not identical. Two of the legs have additional holes towards the bottom. These holes are
used when fitting the wheel brackets. Ensure that you use the two legs with the extra holes on the appropriate side of
the stand.
1.
Use 4 carriage bolts, plain washers, spring washers and nuts to fit a middle brace between two stand legs.
2. Connect a second middle brace to the second pair of stand legs.
3. Use 8 carriage bolts, plain washers, spring washers and nuts to fit the remaining two middle braces.
4. Use 4 carriage bolts, plain washers, spring washers and nuts to attach each long upper brace to the top of the
stand.
5. Use 4 carriage bolts, plain washers, spring washers and nuts to attach each short upper brace to the top of the
stand.
6. Partially tighten all screws and place the stand on its feet.
Fitting the wheels to the stand
1. Attach the wheel brackets to the stand legs using the M6 x 16mm screws with washers and nuts.
2. Add the wheels to the axle and mount the axle between the wheel brackets.
3. Add a circlip to each end of the axle to secure the wheels.
Fitting the table saw to the stand
1. Make sure the blade is completely retracted into the table top.
2. Place the table saw upside down on a protected surface (eg the inside of the shipping carton) so as not to
damage the table top.
3. Turn the stand upside down and place if over the aligning holes in the stand with the matching holes in the
base of the table saw.
4. Secure the table saw to the stand using four hex bolts, plain washers, spring washers and nuts.
5. Fully tighten all screws.
6. Now turn your table saw upright into the normal operating position.