Fox F36-527, Assembly And Operating Instructions Manual

Page: 15 / 24

Fitting the push stick clamps
1.
Use the 4 3.2mm x 10mm long screws provided to attach the push stick clamps to the left hand side of the table
saw.
2. Insert the push stick into the clamps.
NOTE : Always return the push stick to its storage place after use.
Adjusting the laser line
1.
To adjust the laser beam, first take a piece of accurately square cut wood approximately 100mm wide and
300mm long. Draw a line parallel to a long edge approximately 10mm from the edge.
2. Set the mitre fence at 0° (at right angles to the blade) and hold the short edge of the wood against the mitre
fence.
3. Keeping the wood parallel to the blade with the use of the mitre fence, move the wood so that the teeth of the
blade touch the marked line.
4. Check the adjustment and re-adjust if necessary.
Switching on and off
1.
To turn the table saw on, press the green On button.
2. To turn the saw off, press the red Off button.
Overload switch
1.
If the motor is overloaded due to an incorrect procedure such as an attempt to make too large a cut in one pass,
the overload switch located to the right of the On/Off buttons partially pops out.
2. Correct the cause of the overload and ensure the blade is clear of any material that was being cut.
3. Wait several minutes then push in the central part of the overload switch to reset the machine.
4. To restart the machine, press the green On button.
Adjusting the cutting depth
WARNING : The blade lock must be loosened before the blade height is adjusted, and re-tightened once the
desired setting is reached.
1.
Set the saw blade to the required cutting depth by turning the blade height wheel.
2. Turning the wheel anticlockwise increases the cutting depth.
3. Turning the wheel clockwise decreases the cutting depth.
Using the rip fence
Cutting Width
1.
Use the rip fence when making longitudinal cuts.
2. The rip fence can be fitted to either side of the table top. When changing the use of the fence from one side of
the blade to the other, it is necessary to remove the fence from its slide and reposition it on the other side of the
slide. The fence can also be turned through 90° so that the short side of the fence is vertical. This makes it
easier to control the feed of a thin workpiece such as plywood.