Layer 3 Network - Configure Route Scopes
Layer 3 Network - Configure Route Scopes
The configuration views for the Isolation, Registration, Remediation, Dead End, VPN and
Authentication scopes are similar. The Access Point Management scopes configuration view
contains sections for both Production and Isolation clients. Sample Isolation and Access Point
Management views are shown below.
For each set of route scopes you are configuring:
1.
Click
Next
to proceed to the next configuration screen if you are not configuring the
displayed type or select the type from the left-hand navigation pane.
2.
To configure the route scopes displayed, select the
check box
next to the name, such
as Isolation or Registration, and enter the required information. See the table below for
definitions of the fields.
3.
Click
Add
to add scopes or
Modify
to change existing scope information for this route.
4.
Enter the Label, Gateway, and Mask.
5.
In the Lease Pools section, click
Add
to add the lease pool information for the scope.
6.
Enter the IP Addresses for
Start
and
End
of the lease pool range, then click
Add
.
7.
Repeat steps 3 through 6 to create additional scopes and lease pools.
8.
In the Isolation IP Subnets section, enter the list of IP Addresses and corresponding
Subnet Masks indicating IP addresses for which FortiNac will serve DNS.
9.
For the
Access Point Management
scopes, enter the Interface IP Address and
Mask.
10.
Enter the Access Point Management Scopes and Lease Pool information. Add or
modify scopes and associated lease pools.
11.
Enter the
Domain
information in both the
Production
and
Isolation
sections.
12.
Click
Next
when finished.
Table 15: Layer 3 Isolation Field Definitions
Field
Definition
Route Scope Interface eth1
Interface IP
Address
IP address for the Route Scope interface on eth1. Use a different IP for each route
scope type you configure.
Mask
The subnet mask for the interface IP address. Note that the mask is shared between
route scope types. If you modify the mask in one route scope, it changes in all others.
30
Summary of Contents for FortiNac BFN320
