Installation Guide
12
Seconds required to depress button.
MODE 1 (Button 1)
Disable (1 second)
MODE 2 (Button 2)
Enable (3 seconds)
RESET
(Option #23)
This programming option does a master reset on all programming options (1-29) by setting them to
their default value (Mode 1). This does not remove any Transmitter’s from memory.
RESET ALL options to default (Mode 1).
MODE 1 (Button 1)
RESET
PUSH TO START
(Option #24)
Invert the Ignition and Brake wire to adapt the remote-starter to support a push-to-start ignition system.
MODE 1 (Button 1)
Disable
MODE 2 (Button 2)
Enable
MODE 3 (Button 3)
Enable Security: Turn OFF the engine when the door
is open
MODE 4 (Button 4)
Enable Security: Turn OFF the engine when the foot-
brake is pressed
AUXILIARY 1
(Option #25)
Auxiliary 1 channel Configuration.
MODE 1 (Button 1)
Slidding doors (DATA-LINK ONLY)
HYBRID
(Option #26)
Function for hybrid vehicles.
MODE 1 (Button 1)
Disable
MODE 2 (Button 2)
Enable
AUXILIARY 2
(Option #27)
Auxiliary 2 channel Configuration.
MODE 1 (Button 1)
Slidding doors (DATA-LINK ONLY)
NOT AVAILABLE
(Option #28)
ALARM DURATION
(Option #29)
Duration of horn/siren when an alarm is triggered.
MODE 1 (Button 1)
30 seconds
MODE 2 (Button 2)
60 seconds
MODE 3 (Button 3)
120 seconds
VALET CODE
(Option #30)
The
Valet Mode be enabled to prevent an accidental Remote-Start. The alarm system is not
active (including Starter Kill) when the system is in Valet Mode. However you are still able to
lock and unlock the doors, and release the rear hatch/trunk.
VALET CODING DISBALED (DEFAULT):
1. Insert the key and turn it to the ignition (ON/RUN) position. The vehicle does not need
to be started.
2. Within 10 seconds press (1 second) and release the Valet switch 3 times.
3. Valet mode enabled: The LED is ON. Valet mode disabled: The LED is OFF
VALET CODING ENABLED (ENABLE):
1. Insert the key and turn it to the ignition
(ON/RUN)
position.
The vehicle does not need
to be started.
2. Within 10 seconds press and release the valet button 3 to 7 times (X = valet code) for
1 second. If your valet code is 7 then press and release the valet button 7 times.
3. Press and hold the valet button once for 3 seconds to finish the sequence.
4. Valet mode enabled:The LED is ON. Valet mode disabled: The LED is OFF
MODE 1 (Button 1)
Default See User Guide p.6
MODE 2 (Button 2)
Valet code: 3
MODE 3 (Button 3)
Valet code: 4
