FORTEZA TRIBO-M, Operation Manual

Page: 13 / 33

JSC “Forteza” “Forteza Tribo ‐ M” operation manual
13
To prepare cable non ‐ sensitive, proceed as follows:
•
slip a seal for non ‐ sensitive cable over the cable;
•
slip an ebonite bush over the cable;
•
remove the external insulation from non ‐ sensitive cable for a distance of 42 to 44 mm;
•
divide the braided shield into strands;
•
apply the braided shield strands to the ebonite bush;
•
apply tinned ‐ wire serving except for 35 to 40 ‐ mm wire end left uncovered;
•
remove the central conductor insulation except for 18 to 20 mm left at the external insulation
edge;
•
fold the skinned central conductor in two layers and twist it so that the length of the skinned
end comes to 12 mm;
•
shape the central conductor in compliance. Be sure to get a total length of 28 mm;
•
make sure the tail length is 6 mm, minimum.
5.5. Cables Termination in Adapter (Fig. 8)
5.5.1. To terminate the cables in the adapter, proceed as follows (Fig. 8a):
•
pull the spliced ends of the tribocable and non ‐ sensitive cable through the braided shield and
adapter case holes;
•
connect the spliced ends of the tribocable and non ‐ sensitive cable to the corresponding
contacts of the terminal block. Be sure to insulate bare portions of the tribocable and non ‐
sensitive cable central conductors from accidental contact with the braided shield;
•
slip the braided shield over the cable connector and the bush so that the edges of the braided
shield and the bush coincide. In so doing, make sure the tinned ‐ wire leads are arranged
through the centre of the braided shield contact;
•
crimp the braided shield contacts together with the tinned wire. Make sure the diameter is
not in excess of 16 mm;
•
slip the adapter over the braided shield;
•
put gaskets into the adapter case;
•
tighten the screws of two clamps so that the adapter case fits tightly against the cables (make
sure the locations of clamps and gaskets coincide).
To prevent moisture ingress into the adapter use should be made of neutral sealant applied at the
points of the adapter case and gaskets contact.
5.5.2.
To terminate the cables in the extended adapter in equipping gates and wickets (Fig.
8b),
proceed according to Item 5.5.1 but be sure first to slip a required ‐ length spiral
wrap hose over cable РК . Then slip a seal over the spiral wrap hose end. Completing the
cable termination be sure to put the spiral wrap hose end together with the seal into the
case and tighten it with the third additional clamp.
Be sure to tighten only non ‐ sensitive cable seal, not the spiral wrap hose one.