9
Reel holders
A reel holder, which enhances the comfort of assembling, can be attached to the tape feeder. Mount
the Feeder using the M3x4 screws included in the delivery!
You can add or replace SMD reels in any phase of assembling. By default, two pieces (one pair) of
reel holders are sold as an accessory to MPP1
Reel replacement
- turn the shaft so that the safety pin gets into the cut - out and then take
out the shaft. Insert the reels to the guide hole of holder.
Be careful about correct direction
of tape unwinding from the reel.
Insert the shaft through the shaft hole and slide it over the
reels till it fits into the smaller hole in the sidewall on the other side. After moving the safety
pin through the cut - out, turn the shaft by 180º. This lifts the reels and secures the shaft
against ejection. The tapes must always be dragged under the guide bars!
