11
Dispensing head
Dispensing head allows convenient dosing of glue or solder paste from a 5 or 10 ml cartridge.
However, it is necessary to purchase a suitable dispenser.
Description:
Mounting of the dispensing head
Screw the M3 mounting screws into the holes on the assembling head. Insert the dispensing head as
far as it goes under the M3 mounting screws heads. Tighten the M3 mounting screws.
Insert the 10 ml cartridge into the holder so that the end of the dispensing nozzle is at the same height
as the end of the assembling needle. (For a 5 ml cartridge, also insert the spacer ring into the holder.)
Fix the cartridge position by a safety screw. Move the CCD camera to the front position so that the
dispensing nozzle is located in the center of the screen.
Connect the hose into the dispenser (not
included).
Placement of the PCB on the assembling desk
