12
The PCB holders can be removed from assembling desk or relocated by pressing both ends together.
Side holders
Place the PCB holder on the surface of the assembling desk between the side
holders. First, slide the tab on one end of the holder all the way into the
groove at the bottom of the side holder. Lower the PCB holder and the
protrusion will snap into the groove of the second side holder.
Place the printed circuit board on the upper groove of the PCB holders. Set
the spacing between the PCB holders to the width of the PCB. If the size of
the PCB allows it, place more pieces on the work surface.
Vacuum pump
Caution! Use only the vacuum pump that is included
in the delivery (the pumps are specially adapted for use
with manipulators). Switch on the pump before starting the
manipulator and switch it off after manipulator has been
switched off. Set the intensity of the vacuum with the
control valve. The maximum vacuum is required to lift
large or heavy components, for small SMD it is
recommended to reduce the vacuum. The use of rubber
suction cups or a suitable needle diameter significantly
affects the vacuum required to lift the component.
