Fortek Security Systems
Tel: 1-800-505-6476
www.forteksecurity.com
Fax: 1-866-655-6342
8
12 – System Reset
A)
Press and hold the Escape key "ESC" until a double beep is heard. The orange light will remain
on to indicate you have entered into the programming mode.
B)
Press Enter "ENT" key, the green light will blink once.
C)
Press key number nine "9" to enter to the "system reset" operation mode, the green light will
blink once.
D)
Enter the factory default ‘4812446’ or your unique 7 digits controller reset key.
. If the operation was successful, the system will beep twice and the green light will remain ON for
3 seconds.
Once the operation is completed, all the users and settings will be deleted, the password will be
reset to “1234”; and the system will be reset to factory settings.
Security features and error signals:
Upon entering a wrong command key the system will beep once, the orange light will blink
once and remain off indicating that the system exited the programming mode
Upon thirty five seconds(35)of idle time between commands the system will beep once, the
orange light will blink once and remain off indicating that the system exited the
programming mode
After three (3) failed attempts of entering the security password the system will be blocked
for 5 minutes, during that time it will not be possible to enter into the programming mode.
Upon attempt to enroll an already existent credential the light on the reader will remain
green for 10 seconds and the controller will beep 7 times.
Upon attempt to enroll more than one thousand to hundred and sixty(1.260) credentials the
light on the readers will blink for 20 seconds and the orange and green light will turn off
indicating the system exited the programming mode.
To exit the programming mode at any time press escape key “ESC”
