Copyright
©
2015
congatec
AG
PA3Cm11
34/81
Connector Type
X16: 1.25 mm pitch, 1 x 5 Molex PicoBlade pin header
Possible Mating Connector: Molex 51021-0500
Note
congatec offers an adapter cable for the COM port (see section 1.2.3 “Optional Cables). For more information, contact congatec technical
solution department.
5.9
MIPI-CSI 2.0 (Camera)
The conga-PA3 provides a camera interface on connector X55. The interface supports up to two independent cameras – four data lanes for the
first camera and one data lane for the second camera. Each lane operates at up to 1 GT/s depending on the camera resolution. The interfaces
follow the MIPI Alliance CSI-2 specification and support up to 24 MP image capture @ 15 fps, full HD 1080p60, YUV420, YUV422, RGB444,
RGB555, RGB565, RGB888, JPEG and RAW 8/10/12/14.
The table below shows the conga-PA3 MIPI-CSI 2.0 pinout description. The pinout and voltage levels comply with the SGET Camera Feature
Specification.
Table 25 MIPI-CSI 2.0 (Connector X55) Pinout Description
Pin
Signal
Description
1
CAM_PWR
3.3V +/- 5% supply voltage to power the camera device
2
CAM_PWR
3.3V +/- 5% supply voltage to power the camera device
3
CAM0
CSI2 Camera 0 Data Lane 0+
4
CAM0_CSI_D0-
CSI2 Camera 0 Data Lane 0-
5
GND
6
CAM0
CSI2 Camera 0 Data Lane 1+
7
CAM0_CSI_D1-
CSI2 Camera 0 Data Lane 1-
8
GND
9
CAM0
CSI2 Camera 0 Data Lane 2+
10
CAM0_CSI_D2-
CSI2 Camera 0 Data Lane 2-
11
CAM0_RST#
Camera 0 Reset (low active)
12
CAM0
CSI2 Camera 0 Data Lane 3+
13
CAM0_CSI_D3-
CSI2 Camera 0 Data Lane 3-
MIPI-CSI 2.0
(Connector X55)
