Shutting down and restarting the automatic feeder
45
4. Using a clean new water hose, connect the water connector of the automatic feeder to the
water tap that the service technician prepared for the automatic feeder during initial startup.
5. Connect the milk connector of the automatic feeder to the milk tank using a clean new hose.
6. Connect the teat to the feeding station valve (rationed mode) or the mixer jar (ad lib mode).
Use a new hose for this connection.
The hose must be installed at a gradient to the automatic feeder without sag-
ging. This makes it easier for calves to consume feed and facilitates draining the hose (see
figure).
50-80 cm
10-15 cm
Hose with gradient between teat and feding station valve
If your automatic feeder has a mixer drain valve, connect the mixer drain valve to the drain
channel. Use a new hose for this connection.
7. Insert the mains plug into the outlet that your service technician created for the automatic
feeder during initial startup.
8. Switch on the automatic feeder using the control switch.
Failure, HE not filled
appears in the display of the hand terminal.
9. Press
.
Confirm
HE: fill?
by choosing
.
Summary of Contents for TAK5-CH2-25
