Running the automatic feeder
109
Proceed as follows to calibrate detergent using the calibration scale:
1. Choose
> Calibration
to go to the
Components
submenu.
2. In
Detergent
, you recalibrate the cleaning agent.
•
Confirm
Detergent
by choosing
.
•
In
Set quantity
, you can check the amount of cleaning agent that the automatic
feeder will dispense.
•
In
Runtime
, you can check the time in which the automatic feeder will dispense
cleaning agent.
•
In
Date
, you can check when the cleaning agent was last recalibrated.
•
Confirm
Start?
by choosing
.
•
Confirm
Exit automatic mode?
by choosing
This message is only displayed
if your automatic feeder is still operating in automatic mode.
•
Place the calibration box into the mixer jar and confirm the prompt
Calibration box
used?
by choosing
.
•
Detergent is dispensed into the calibration box.
•
Confirm
Confirm value....
by choosing
.
•
In
Date
, you enter the current date.
•
Remove the calibration box from the mixer jar.
•
Repeat the recalibration in order to check your results.
6.7.3.1.1 Replacing hoses and teats
•
Replace the milk suction hose, which goes from the milk tank to the automatic feeder. This
reduces the risk of infection. New hoses are available from your dealer.
•
Replace all feed-conducting hoses that run from the mixer to the feeding stations. This re-
duces the risk of infection. New hoses are available from your dealer.
•
Replace all teats. This reduces the risk of infection. New teats are available from your deal-
er.
Summary of Contents for TAK5-CH2-25
