11
Connect the wires from the Lamp Base with the
wires in the lower part of the Motor Assembly using
the pre-installed electric connexions. White with
White, Black with Black.
Align the window in the underside of the Motor
Assembly with the protrusion in the back of the
Lamp Base. Push the Lamp Base up making sure
they fit together. Replace the 3 screws you
removed. Tighten them.
Lift the Lamp Shade and push it gently into the
Lamp Base.
Turn clockwise to lock in place.
DO NOT overtighten as this may crack the Shade.
Remove the 3 screws in the underside of the Motor Assembly.
Installing the Blades for Down Rod and Flush Mount
Installing the Light
Take 2 Blade Screws from Pack of Blade Screws (9) and make sure that
the spring washer and the flat washer are in place with the flat washer
towards the threads of the screw.
Align the window on the lower part of the Motor Assembly with 2 screw
holes in the motor.
Insert the 2 Blade Screws with Blade Washers and tighten them securely
with a Philips screwdriver.
Check that the 2 screws are tight before you go to the next step.
Rotate the secure blade until you can align another set of screw holes in
the motor with the window in the lower part of the Motor Assembly.
HAND TIGHTEN ONLY. DO NOT USE A POWER TOOL TO TIGHTEN
BLADE SCREWS.
Repeat the process for the other 2 Blades.
From here on the installation is the same for
both Down Rod and Flush Mount Installation
Window
Protrusion
Window
Protrusion
Connexions
Connexi
