9
Using the wire connectors:
1. Connect the L (Black) wire from your Receiver to
the Live (Black) wire from your ceiling electric
box.
2. Connect the N (White) wire from your receiver
to the Neutral (White) wire from your ceiling
electric box.
3. Connect the green Ground wire that comes
from the receiver to the green wire that comes
from your Bracket, also to the green wire (if
there is one) that comes from your box and at
the same time to the bare or green wire that
comes from your electric supply wire bundle.
Remove 3 opposing screws from the Yoke in the
top side of the Motor Assembly. Save the screws.
Thread the wires from the Motor Assembly through
the centre of the canopy.
Place the Canopy so that the 3 large holes in the
Canopy align with the 3 heads of the screws you
left on the Yoke.
The 3 small holes should align with the threads in
the Yoke. Replace the 3 screws you took out in
those holes and tighten.
White Supply Wire
Ground
(green or
bare)
Ground
(green or
bare)
Green Ground
Receiver
White
AC IN N
White
Black
Black
AC IN L
Black Supply Wire
From Receiver
From Receiver
From Ceiling
From Ceiling
!
WARNING: Failure to disconnect
power supply to the box may result in
serious injury. Double check now that
the circuit breakers to the box are off.
Flush Mount Installation
Flush Mount
Flush Mount Installation
Electrical Installation for Flush Mount
Wrap each wire connector with
Electrical Tape for extra safety
*
*
