The saturation of greasy residue in the blower and filters may cause increased inflammability. Keep unit
clean and free of grease and residue build-up at all times to prevent possible fires.
Filters must be cleaned periodically and free from accumulation of cooking residue (see cleaning
instructions inside). Old and worn filters must be replaced immediately. Do not operate blowers when
filters are removed. Never disassemble parts to clean without proper instructions. Disassembly is
recommended to be performed by qualified personnel only. Call our service center for removal
instructions.
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its fine
appearance.
Cleaning tips:
* Hot water with soap or detergent is all that is usually needed.
* Rinse with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
* For discolorations or deposits that persist, use a non-scratching household cleanser or stainless steel
polishing powder with a little amount of water and a soft cloth.
* For stubborn stain, use a plastic scouring pad or soft bristle brush together with cleanser and water.
Rub lightly in direction of polishing lines or “grain” of the stainless finish. Avoid using too much
pressure that may mar the surface.
* Do not allow deposits to remain for long periods of time.
* Do not use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing
rust.
* Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these compounds contain chemicals that may be
harmful. Rinse with water after exposure and wipe dry with a clean cloth.
* Painted surfaces should be cleaned with warm water and mild detergent only.
LIGHT bulbs
WARNING:
Please ensure lights have been switched off for some time and the power source has been
disconnected before replacing any globes. Please be aware that the light will retain hear for
a short period of time after being switched off.
Step 1: Turn anti-clockwise to open
Step 2: Take the existing globe out
Step 3: Insert a new globe (GU10 Fitting) and turn clockwise in lock position
