16
WWW.FORNEYIND.COM
Step 7: Route the wire through the drive mechanism.
•
Ensure that the wire leaves the liner outlet guide.
•
Using your fingertips, route the wire past the drive roller and into the torch neck inlet guide.
Step 8: Close the tension arms and apply drive tension (reverse Step 5).
•
Rotate the tension arms inward toward the drive roller.
•
Lock the arms in place around the torch neck inlet guide block.
•
Ensure that the welding wire is centered in the upper groove of the drive roller.
•
Apply drive tension by rotating the drive tension knob (G) clockwise until snug.
•
TIP: More tension is not better! Use as little drive tension as possible while still feeding wire smoothly
and continuously.
Step 9: Re-install wire spool cover (reverse Step 1).
•
Place spool cover back into position over wire spool compartment.
•
Pressing with an inward force, rotate the spool cover knob approximately 90 degrees clockwise.
Step 10: Verify this setup by depressing the spool gun trigger.
•
Depressing the trigger should feed wire through the torch neck and out the nozzle of the spool gun. Feed
several inches to ensure smooth operation.
