9
_________________________________________________________________________________
3.2 Setting up the envelope sealing machine
1.
The Envelope Sealing Machine must be placed on a level and solid base. The
boxes must be placed on the surface.
2.
The Envelope Sealing Machine must be connected to a 115 vac grounded
outlet.
When setting up, the machine must always be turned off
(the warning light must not be blinking!)
3.
The machine can be leveled by adjusting the two rear machine feet
and
aligning the c
ircular
bubble
level on the basin.
4.
Check whether the circular level has moved. If necessary, adjust the
machine feet again.
5.
The transparent water reservoir must be filled with tap water. If the tank
were to tip over quickly the valve closes off the water.
In hard water areas add 4 to 5 drops of cleaning fluid. This
way you will have a equally smooth and spot-free liquid!
6.
The moistening basin should be topped up
to the limit and the water
reservoir (neck down) inserted into this position inside the ring of the
moistening basin until the neck completely rests inside.
7.
The water must now reach the top of the moistening roller. Check for the
optimal wetness manually when turning the moistening roller.
8.
The correct amount of water will now automatically be supplied to
the moistening roller from the transparent water reservoir (vacuum
effect
.
)
The suction rubber pear is used to check the water level
and to empty the moisture basin.
When carrying out maintenance or moving the machine, the
wa
ter basin and reservoir must be completely emptied.
9.
The moisture basin must be covered and the water reservoir
bottle removed from
the ring-shaped holder
.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
