Operating Manual
38
1/97
1. Clean the
F
D
150
exterior surfaces periodically with a
mild soap cleaner and a cloth. This will help maintain
the appearance and operation of the machine.
NOTE
If you cannot remove ink from the
F
D
150
with a
mild soap cleaner, use lemon extract.
√
Tip: Clean ink off your hands with rubbing alcohol or pumice soap.
2. Using compressed air, blow away any dust or debris
from the outside of the
F
D
150
.
3. Open the COVER.
4. Using compressed air, blow away any dust or debris
from the inside of the
F
D
150
. Aim at the photosensors.
NOTE
Do not hold the compressed air can close enough
to the PHOTOSENSORS to freeze them.
5. Clean the FEED ROLL, TRANSPORT ROLLS,
BUMPER WHEEL (which is on the FEED TRAY),
SADDLE HOLDER, IMPRINT SADDLES and the
BACKUP PLATEN with isopropyl alcohol and a cloth.
NOTE
Clean the PRESSURE TIRES with a dry cloth or
dry coarse brush ONLY. Do not clean these rolls
with alcohol or any other liquid cleaner.
6. Close the COVER.
7.3 Replacing
A
Fuse
When one or both FUSES are blown, the
F
D
150
will
appear to have no power. If the
F
D
150
has blown a FUSE,
replace the fuse. The FUSE DRAWER is located on the
input end of the machine. Use the following instructions to
replace one or both FUSES. (Refer to
Figure 7.3.
)
