8.1.2.5 Install the fastening screws 2 (fig. 32).
8.1.2.6 Unscrew both transport lugs 1 (figure 33) and replace them with the
mounting screws 1 and 2 (fig.33).
Figure 33.
8.1.2.7 Slightly unscrew the first screw on the left side of the clamping screw 2
(fig.32), taking care that the screw head does not protrude above the knife
beam sliding plane.
8.1.2.8 Press the "knife change" function on the 3 programmer (fig.23)
8.1.2.9 Pressing the push buttons 2
(fig. 35) at the same time, start the cutting
cycle. The knife will stop in the lower position.
8.1.2.10. Switch off the power supply of the electrical system by turning the main
switch knob 1 (fig. 34) to the "0" position
Summary of Contents for Cut-True 31H
