INSTALLATION
7
8. • Cut two pieces of adhesive foam
seal to the height of the window
opening.
• Remove the backing and apply on
the inside edges of the vertical
window sash frame (fig. C).
9. • Put the unit on the support platform.
• Check for the unit side rail to butt
against the edge of the window
vertical frame.
•
If the unit side rail does not
correctly fit, remove the unit and
adjust leveling bolt.
12. Secure the installation by fixing the speed clips on the inside edge of the window top and
bottom frame (fig. E,
next page
).
13. Cut a seal to proper length and
insert it between the inside and the
outside window sash
(fig. E,
next page
)
14. •Place the top retainer on the top
edge of the filler panel.
• Then place the bottom edge of the
filler panel Into the groove of the
unit bottom mounting rail.
• The filler panel should be trimmed
to tightly fit in the window opening
(fig. C).
15. Insert the sliders upward making
sure the filler panel aligns in sliders.
16. •With sliders up against top retainer, drill on each side a 1/8” hole through the
window frame in alignment with the pre-drilled holes in the sliders.
•Insert 3/8” screws and tighten.
10.• Drill 2 x 1/8” holes through the window sash frame in alignment with the holes in
the unit bottom rail (factory installed).
• Insert 2 x 3/8” screws through these holes.
• If the window sash frame is not long enough to use the pre-drilled holes, drill new
holes off and attach the bottom part of the air conditioner to the support platform.
• The air conditioner should be firmly anchored to window rail frame or support
platform (Fig. D).
11. • Close the window.
• Check for the inside edge of window vertical frame to close tightly on side of unit.
• Cut remaining adhesive foam seal to width of the window opening.
• Remove backing and fix it into inside edge of the top window frame (Fig.C).
C
C
Foam seal
Foam seal
Top retainer
Filler panel
Slider
Support platform
Bottom mounting rail
3/8” screws
Drilled holes
Window sash frame
C
D
