FE1-23
EN
Copyright © 2015
P a g e
|
12
www.Ford-tools.com
13
OPERATION
13.1
Switching on and off (fig 10)
Attention!
Before working with the angle grinder, check that the voltage shown on the
machine’s model plate is the same as the mains voltage being used.
Before engage the ON/OFF switch trigger, check that the grinding disc is properly
fitted and run smoothly, the outer flange is well tightened.
Switching on
1. Insert the plug into a correctly installed mains socket.
2. Push forward the ON / OFF switch with safety button (5) (
See the arrow (1)
on Fig. 10
), and at the same time depress it firmly inwards and keep it pressed
(
See the arrow (2))
.
Switching off
When you release the switch, the tool turns off.
Do not let go of grinder until it has stopped running.
Warning:
The wheel continues to rotate after the tool is switched off.
14
USE
14.1
Grinding
Hold the handle (4) and auxiliary handle (8) firmly
and switch on. Avoid blocking the ventilation slots
with your hand, as this may cause the grinder to
overheat. Let the disc reach full speed.
Apply the grinder to the item. Maximum effect is
achieved when the grinder
is held at an angle of 15-30°in relation to the item.
Move the grinder gently along the item. Give the grinder time to work. It is rarely
necessary to press the disc hard against the surface to be worked.
Sparks can occur in the motor compartment during use. This is normal and does
not mean the grinder is defective.
Switch off the grinder after use.
