Fonexion ideus ITCOMBO100, User Manual

Page: 36 / 109

EN
USER GUIDE
36
ITCOMBO100
Press MENU key to confirm. Enter the PIN code using the keypad (if you haven’t changed
it, the default PIN is 0000).
Press MENU key to confirm. If the old code is validated, the user will be prompted to
enter a new PIN code.
Use the keypad to enter the new PIN (4 digits from 0-9)
Press MENU key to confirm. Use the keypad to enter the new PIN again and press MENU
key to confirm.
*If you enter the wrong PIN at any time you will hear an error tone and the display will return to
the previous menu.
BASE DEFAULT
This function allows the user to restore the base setting to the factory default. The call log will be
cleared but the phonebook will not be changed.
Using
▲
/CID or
▼
/OUT key to select BS DEFAULT item.
Press MENU key to confirm.
The user will be promoted to enter the PIN code. Enter the PIN code using the keypad
(Default PIN is 0000)
Press MENU key to confirm. If the PIN code is validated, all base settings will be returned
to the factory default.
BASE Menu function 4: REGISTRATION
The handset supplied with the base unit is already registered. You don’t need to re-register them,
unless you have a problem. Make sure mains power to the base unit is switched on and the
handset is within range. To check whether a handset is registered, the handset’s display should
show its number, and the “signal strength” symbol on the display should show three bars. If not,
you need to re-register the handset again using the following process:
Note: You need to operate the base and handset together
On the base, press MENU key.
Press
▲
/CID or
▼
/OUT key to select REGISTRATION item.
Press MENU key to enter. LCD shows SEARCHING and it flashes. If registration is
successfully, the base will return to standby mode.
At the same time, on the handset, press PHONEBOOK key to see PHONE BOOK
Press the direction keys to select REGISTRATION
Press SET key to see BASE 1 (If the handset already has a registration to a base there is
a “+” on the right side of the display, and you should choose another base number if you
don’t want to loose that one).
Press SET/OK (
) key to confirm. The display shows PIN?, key in the 4 digit PIN code
for the base (the default PIN code is 0000).
Press SET/OK key to confirm, and the display will flash “SEARCHING 1”(or 2,3,4)
After a short delay, if the registration is successful, there will be a confirmation beep, and
the handset display will go back to standby mode with the new handset number shown (e.g.
HS1,HS2). The base display will also go back to standby mode.
Note: During registering, the base and the handset in a short distance may be better for
registration.