Fona MyCrown Mill, Service Manual

Page: 83 / 98

83
Service Manual
båÖäáëÜ
5. Place the door switch solenoid cable to one side and rotate the
suction connection clockwise until the hose with the suction
connection can be pulled out underneath the metal bracket.
6. Unscrew the rear rubber-metal mountings (B) and slide the rails
toward the rear (TX 10 screwdriver).
7. Disconnect the plug connection of the tank switch and carefully pull
out the chassis insert.
4.7.3 Installing the chassis insert
1. Insert the chassis insert carefully.
2. Insert the rails toward the front and screw on the rear rubber-metal
mountings B.
Taking out the chassis insert
3. Push through the hose with the suction connection underneath the
metal bracket and rotate the suction connection counterclockwise
until the suction connection with hose can be laid to the rear in space
A. Then run the door switch solenoid cable back into space A.
4. Reconnect the plug connection of the tank switch.
5. Plug the hose into the suction end of the water pump and fasten it with
the hose clip.
6. Insert the cooling pack.
7. Insert the fan unit so that the embossed arrows on the fan point
upward and to the rear.
8. Screw on the fan unit with the 4 screws.