Fona MyCrown Mill, Service Manual

Page: 61 / 98

61
Service Manual
båÖäáëÜ
4. Grease motor O-ring of the motor A and the bulge C sparingly.
5. Place the motor B in the motor mount.
The hole for the air connection E must lie on the O-ring in the motor
mount.
6. Insert the power supply cable D in the motor mount guide provided
for this purpose.
7. Apply a light coat of the Loctite sealer included in the scope of supply
to the threads of the motor fastening screws
8. Turn the motor so that the holes of the motor mount line up with the
holes of the motor.
9. Screw the motor mount and motor together.
Installing the motor in the unit 1. Push the mount cover onto the shaft as far as it will go.
2. Push the motor along with the motor mount onto the shaft.
3. Connect the power supply connectors.
A Motor O-ring D Power supply cable
B Spindle motor E Hole for air connection
C Bulge
NOTICE
Press the motor slightly from the rear until you have securely screwed it
onto the motor mount. This prevents the O-ring from slipping.
NOTICE
Do not damage the cables
Be careful not to damage any electrical cables when pushing the mount
cover onto the shaft. Place the socket in the shaft.
NOTICE
Proper connection of the power supply
Make sure to connect the socket for the power supply of the DC motor
to the cable for Bur Set 1. The socket for Bur Set 1 is labeled with a red
dot.
The red dots on the connectors must be on the same side when
connected.