22
110CT/CR/FB Ice and Water Dispensers
Disassembly and replacement instructions
Dispense chute removal
1. Remove dispenser front cover.
2. Slide plastic dispense chute up and out to
remove.
Dispense wheel and drive bar removal
1. Remove all ice from storage area of
dispenser.
2. Remove center thumbnut from dispense
wheel.
3. Remove thumbnuts holding baffle inside
bin and remove baffle.
4. Tilt rear of wheel up and lift off motor
drive shaft.
5. After reinstalling wheel, secure baffle
loosely with thumbnuts, but do not
tighten.
6. Place a 1/8" (3.2 mm) spacer against
wheel and allow baffle to drop until it
touches spacer.
7. Tighten thumbnuts and remove spacer.
Drive bar removal
1. Remove dispense wheel from dispenser
(see above).
2. Pull drive bar out of its channel in bottom
of wheel.
Wheelmotor removal
1. Shut water off. Remove front cover.
2. Remove dispense wheel and dispense
chute covers (see above).
3. Remove splash panel. Water line to
solenoid valve can be disconnected from
water inlet valve by pulling on ring at end
of inlet fitting.
4. Disconnect wiring to panel and set panel
aside.
5. Disconnect wires on motor.
6. Remove four bolts (7/16" socket) holding
motor assembly to bottom of dispenser.
7. Remove motor assembly.
Fig. 6
side view wheel section
dispenser
front
baffle
3.2mm (1/8")
spacer
