Follett E7CI100A, Installation, Operation And Service Manual

Page: 18 / 40

18 Dispenser and Ice machine E7CI100A/E7FS100A
Service
(continued) –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
21. Remove and discard mating ring and seal (Fig. 23.1) .
22. Carefully remove auger (Fig. 23.2) .
WARNING!
Use caution when removing auger. The auger is very
sharp - handle with care to avoid personal injury.
Fig. 23
1
2
Evaporator Assembly
1. Remove and inspect main housing O-ring seal.
Replace if damaged in any way.
2. Clean O-ring groove. Lubricate O-ring with Petro-gel
and reinstall.
3. Use cardboard disc to press new mating ring into
main housing
(Fig. 24.1) .
4. Lube the shaft with liquid soap in the area shown
(Fig. 24.2) and slip on seal and spring (Fig. 24.3) .
Note: Do not touch the sealing surfaces with bare hands.
Contact with bare skin will cause premature seal
failure.
5. Install auger (Fig. 24.4) .
Fig. 24
Cardboard
disc
Do NOT
touch!
1
3
4
2
6. Install main housing:
§
Slide main housing onto auger shaft (Fig. 25.1) .
§
Install three M6x25 allen screws (Fig. 25.1) .
§
Connect vent line to T fi tting (Fig. 25.1) .
Fig. 25
1
2
3