FT-5 User Manual Page 59
12.
Snap both ends back in, making sure the wires are
not pinched.
13.
Cut the thermistor down to 5 inches and strip the
ends of the wires. Do the same to the hotend fan
wires. Take the white small 4 pin connector and
solder the thermistor wires and fan wires in the
following order: white, white, red, black. The
orientation of the thermistor is not important but
the fan wires are. Make sure to feed on heat
shrink before soldering and then cover the solder
with heat shrink.
14.
Insert the two green, red, and black 24 awg wires
into the white connector in the following order
(left to right). Green, Green, Red, Black.
Note that the green wires should line up with the
two thermistor wires. The red and black wires
should line up with the red and black wires from
the extruder fan.
